spot the differance… the caliper was resting on the brake disk — at Twin Motorcycles Buell Support forever.
draining the old caliper
brake line off
we going to use a good 2e hand caliper from a XB on the used bracket
mounting the bracket and wheel
need to bleed the system
no scraping noise anymore
and she can go for the 2e 100.000 KM ?
starting problem uly..
very strange problem.. very much current is drawn when you push the starter button.. the stock fuse pops.. with 30 amp fuse the starter button spring become a heat spiral.. no bueno.. pulling out the relais.. as the starter button sould only be a switch for the relais
.jpg)
some one has been looking for this already.. don’t like how the cable harness was left behind the headlights
just checking.. other starter button… mnnn don’t know what happened.. but it starts now with out a problem ..
just checking.. other starter button… mnnn don’t know what happened.. but it starts now with out a problem ..
checking the resitance on the buttons .. — at Twin Motorcycles Buell Support forever.
bought good.. mnnnn.. funny , need to let this sink in a little , as everything works no.. very hard to trace back
clutch noise.. and bad to adjust ..
just having a look inside, i suspect the hub bearing.. draining the oil
clutch mechnism out
shifter removed
and taking of the cover
shit.. yes hub bearing… missed that with the cover replacement , did not look for it , and did not expect this on this clean bike
.jpg)
see this happen more
pressing it out
and new bearing in and pressed on
with our removing the front sprocket… chain on the basket and than on the front sprocket.. hold in the middle and push the hub back in
red loctite on the shaft and tighten the nut
puller plate back on.. the c-clip has seen better days
these become oval from taking out and mounting..see here the difference with a new one.. spoil the bike sometimes.. and put a new one in 
🙂
cover back on.. tighten it starting in the middle and spiral out
loctite on the shifter bolts
setting the primairy tension , and adjusting the clutch.. she is good to go
trouble Uly.. been trying all day.. started every time.. hold the cable harness and she did the problem again.. mnn..
bike back on the lift
not sure i like the mounting of the light grounds
for sure do not like the wire loom with out isolation around the steering head
front wheel axle ..out to remove 1 front leg.. i will lube this one during mounting
leg out.
and cable guide loose
now checking and testing the wires
https://www.twinmotorcycles.nl/artikelen.asp?cid=20&aid=2287
Twin Motorcycles Netherlands 